IKEA · Kids' Furniture
How to assemble IKEA SUNDVIK Crib
Step-by-step IKEA SUNDVIK Crib assembly: 13 illustrated steps, an animated video, the hardware list and the tools you need — following the official instructions (AA-750498-9).
- 13 illustrated steps
- 7 steps in the manual
- 2:04 video
- 141×79×85 cm cm
What you need
Tools
- Flat-head screwdriver
- Phillips screwdriver
- Hammer
- Allen key (included)
Hardware in the box
| Part no. (as printed in the manual) | Qty |
|---|---|
| 105657 | 4× |
| 105907 | 8× |
| 130718 | 4× |
| 101351 | 8× |
| 110301 | 4× |
| 147168 | 4× |
| 119245 | 4× |
| 100514 | 8× |
Step-by-step assembly
Step 1
Push 4 dowels (101351) into one end of the two long sides.
One in the end of each top and bottom rail.
Step 2
Put 4 barrel nuts (100514) into the rails.
Line up the slots with a flat screwdriver.
Step 3 · manual step 2
Bolt both long sides to one end panel: 4 bolts (105907).
Tighten with Allen key 100092.
Step 4 · manual step 3
Push 4 bolts (130718) down through the base’s corner blocks.
Check the corner blocks sit as shown in the manual, step 3.
Step 5 · manual step 3
Underneath: an arm (105657) and a cap nut (110301) on each bolt.
Hold with Allen key 100092, tighten with 100001.
Step 6 · manual step 4
Stand the frame on its end.
The end panel you just fixed lies on the floor.
Step 7 · manual step 4
Lower the base in: 2 arms go into the holes in the legs.
Push them in by hand — no hammer. Upper holes for a baby, lower holes once it can stand.
Step 8 · manual step 5
Push 4 dowels (101351) into the top ends of the long sides.
Step 9 · manual step 6
Put the other end panel on top, onto the dowels and the 2 arms.
Guide the base arms up into the holes in the legs.
Step 10 · manual step 6
Put 4 barrel nuts (100514) into the rails.
Line up the slots with a flat screwdriver.
Step 11 · manual step 6
Tighten 4 bolts (105907) through the end panel.
Allen key 100092.
Step 12 · manual step 7
Turn the crib upright.
Step 13 · manual step 7
Fix 4 fittings (119245) to the legs with 4 screws (147168).
Fitting on the inside of each leg, screw from the outside. Phillips screwdriver.
Tips & safety
- Two base heights. Upper position for a small baby; lower position once your baby can stand up (manual p. 6 and 10–12). Toddler-bed conversion: see the manual, p. 13–20.
- Assemble with two people. The manual shows two people and a soft surface on the floor.
Official instructions
This guide follows IKEA’s official assembly instructions (AA-750498-9). Keep the printed manual to hand — if anything differs, the manual is right.
