How to assemble IKEA ANTILOP High Chair with Tray

Step-by-step assembly

1. 

   Step 1

   Check the parts before you start.

   Seat shell with safety belt, 4 legs and the tray. Everything clicks together by hand.

   ▶ Watch this step (0:11)

2. 

   Step 2 · manual step 1

   Lay the seat shell upside down on a table.

   The backrest hangs down over the edge. Have the 4 legs ready.

   ▶ Watch this step (0:17)

3. 

   Step 3 · manual step 1

   Push a leg into a socket until the button clicks.

   You hear a CLICK and see the button in the hole. Check it on every leg.

   ▶ Watch this step (0:24)

4. 

   Step 4 · manual step 1

   Push in the other 3 legs the same way.

   Each one must click in.

   ▶ Watch this step (0:32)

5. 

   Step 5

   Turn the chair over and stand it on its legs.

   ▶ Watch this step (0:41)

6. 

   Step 6 · manual step 2

   Safety belt: press both tabs on the buckle and pull it apart.

   Then push the 2 halves together again until it clicks.

   ▶ Watch this step (0:47)

7. 

   Step 7 · manual step 3

   Lay the chair upside down on the table again.

   The 3 strap ends are under the seat.

   ▶ Watch this step (0:55)

8. 

   Step 8 · manual step 3

   Thread each strap end through its anchor (3x).

   Push the end through the anchor and fold it back over it — all 3 strap ends.

   ▶ Watch this step (1:01)

9. 

   Step 9 · manual step 3

   Stand the chair up again.

   The strap ends hang straight under the seat — not in a loop.

   ▶ Watch this step (1:10)

10. 

    Step 10

    Now the tray.

    It has its own manual (AA-2297812-2) — step numbers start again at 1.

    ▶ Watch this step (1:16)

11. 

    Step 11 · manual step 1

    Set the back ends of the tray on the armrests.

    Hold the front up; the 2 hooks underneath go into the 2 slots in the armrests.

    ▶ Watch this step (1:20)

12. 

    Step 12 · manual step 2

    Press the tray down until it locks in place.

    ▶ Watch this step (1:27)