IKEA · Dressers & Drawer Units
How to assemble IKEA KOMPLEMENT Storage with 4 Compartments
Step-by-step IKEA KOMPLEMENT Storage with 4 Compartments assembly: 9 illustrated steps, an animated video, the hardware list and the tools you need — following the official instructions (AA-2050731-2).
- 9 illustrated steps
- 4 steps in the manual
- 1:33 video
- 25×53×5 cm cm
What you need
Tools
No tools needed.
Hardware in the box
See the manual.
Step-by-step assembly
Step 1
Work on a soft surface, like a rug.
The manual shows this so the tray is not scratched or damaged.
Step 2 · manual step 1
Peel the backing off the 4 triangular pads.
Lay them sticky side up.
Step 3 · manual step 2
Turn the tray upside down.
Keep it on the soft surface.
Step 4 · manual step 2
Stick a pad into each corner of the underside.
One pad in each corner — 4 pads.
Step 5 · manual step 2
Each pad fits right into its corner.
Step 6 · manual step 3
Peel the backing off both strips.
2 strips.
Step 7 · manual step 4
Turn the tray the right way up.
Step 8 · manual step 4
Stick one strip inside each short end.
Centred on the end, 5 mm (3/16") below the top edge.
Step 9 · manual step 4
Leave a 5 mm (3/16") gap above the strip.
Same on both ends.
Tips & safety
- Assemble on a soft surface. A rug or blanket protects the tray (manual page 2).
- Wider KOMPLEMENT trays put the strips elsewhere. On those, the strips go along the long sides — see page 4 of the manual.
Official instructions
This guide follows IKEA’s official assembly instructions (AA-2050731-2). Keep the printed manual to hand — if anything differs, the manual is right.
