IKEA · Chairs & Stools
How to assemble IKEA SKOGSTA Chair
Step-by-step IKEA SKOGSTA Chair assembly: 9 illustrated steps, an animated video, the hardware list and the tools you need — following the official instructions (AA-2376791-5).
- 9 illustrated steps
- 5 steps in the manual
- 1:40 video
- 43×51×92 cm cm
What you need
Tools
- Flat-head screwdriver
- Allen key (included)
You’ll need a flat-blade screwdriver. The Allen key is included.
Hardware in the box
| Part no. (as printed in the manual) | Qty |
|---|---|
| 110467 | 2× |
| 114575 | 6× |
| 100842 | 6× |
| 100514 | 2× |
Step-by-step assembly
Step 1
Lay the seat upside down on a table.
Put a cloth under it. The backrest hangs down over the edge.
Step 2
Set one leg frame onto the seat.
The legs point up, the cleat lies flat on the seat.
Step 3 · manual step 2
Fit 3 short bolts (114575) with 3 washers (100842).
Not the long bolts. Screw them in loosely — the washers must not be flat yet.
Step 4 · manual step 3
Fit the other leg frame the same way.
3 short bolts (114575) and 3 washers (100842), still loose.
Step 5 · manual step 4
Push 2 barrel nuts (100514) into the cross rail.
One near each end.
Step 6 · manual step 4
Lay the cross rail between the two side rails.
Step 7 · manual step 4
Join them with 2 long bolts (110467) and the Allen key.
Hold the barrel nut in line with a flat screwdriver — see the manual, step 4.
Step 8 · manual step 5
Now tighten all 6 seat bolts with the Allen key.
Tighten until the washers are pressed flat.
Step 9
Turn the chair upright.
Your SKOGSTA chair is ready.
Tips & safety
- Bolts loose first, tight last. Tighten the seat bolts only in step 5.
- Work on a cloth. Lay the seat on a cloth so it doesn’t get scratched.
Official instructions
This guide follows IKEA’s official assembly instructions (AA-2376791-5). Keep the printed manual to hand — if anything differs, the manual is right.
