IKEA · Chairs & Stools
How to assemble IKEA NÄMMARÖ Chaise
Step-by-step IKEA NÄMMARÖ Chaise assembly: 17 illustrated steps, an animated video, the hardware list and the tools you need — following the official instructions (AA-2307889-5).
- 17 illustrated steps
- 13 steps in the manual
- 2:30 video
- 200×65×34 cm
What you need
Tools
- Flat-head screwdriver
- Allen key (included)
- Spanner (included)
You’ll need: a flat-head screwdriver.
Hardware in the box
| Part no. (as printed in the manual) | Qty |
|---|---|
| 10089529 | 2× |
| 113134 | 2× |
| 114729 | 4× |
| 128832 | 2× |
| 117215 | 2× |
| 112074 | 2× |
| 116562 | 4× |
| 10089533 | 2× |
| 113153 | 2× |
| 114577 | 4× |
| 117217 | 6× |
| 106675 | 4× |
Step-by-step assembly
Step 1
Lay the chaise frame upside down on a rug.
The slatted seat and backrest come ready-made.
Step 2 · manual step 1
Push a cross dowel (116562) into the top of each leg.
Use 116562 here — not 10089533 or 113153.
Step 3 · manual step 1
Screw a threaded rod (114729) into each leg.
Turn it in by hand until it meets the cross dowel.
Step 4 · manual step 2
Fit the 2 legs with the oval hole at the backrest end.
The rods go through the corner brackets. Mind your fingers.
Step 5 · manual step 3
Place the crossbar between the legs at the bottom.
The holes in its top face upwards.
Step 6 · manual step 4
Push 2 cross dowels (10089533) into the crossbar.
Step 7 · manual step 5
Put each wheel on a bolt (10089529) with washers and spacers.
Washer, spacer 117215, wheel, washer, spacer 112074, washer — see the manual, step 5.
Step 8 · manual step 6
Screw the wheels through the legs into the crossbar.
Hold the cross dowel with a flat screwdriver; tighten with the spanner (128632).
Step 9 · manual step 7
Tighten a nut (114577) with a spring washer (106675) on each rod.
Use the spanner (128632).
Step 10 · manual step 8
Fit the other 2 legs at the foot end the same way.
Step 11 · manual step 9
Push a dowel (128832) into each end of the second crossbar.
Step 12 · manual step 10
Fit the crossbar between the legs at the bottom.
The dowels go into the holes in the legs.
Step 13 · manual step 11
Push 2 cross dowels (113153) into the crossbar.
Step 14 · manual step 12
Screw 2 bolts (113134) through the legs into the crossbar.
Use the Allen key (100001); line up the cross dowel with a flat screwdriver.
Step 15 · manual step 13
Tighten the nuts (114577) and spring washers (106675) here too.
Use the spanner (128632).
Step 16
With two people, turn the chaise over onto its legs and wheels.
Mind your fingers.
Step 17
Lift the backrest to the position you like.
The support folds out and rests in the notches — see the manual, page 15.
Tips & safety
- Watch your fingers. The manual warns of pinching when fitting the legs and when turning the chaise over.
- Turn it over with two people. As the manual shows — lift it clear of the floor, then set it down on its legs and wheels.
- Missing a part or unsure? The manual says: contact your IKEA store for help.
Official instructions
This guide follows IKEA’s official assembly instructions (AA-2307889-5). Keep the printed manual to hand — if anything differs, the manual is right.
