How to assemble IKEA HAUGA Chair

Step-by-step assembly

1. 

   Step 1

   Press 2 brackets (122620) into each seat rail.

   Lay the two seat rails flat on a rug, holes facing up.

   ▶ Watch this step (0:16)

2. 

   Step 2

   Push 16 dowels (101350) into the ends of the 4 cross pieces.

   Lay a side frame flat. 2 dowels in each end.

   ▶ Watch this step (0:23)

3. 

   Step 3 · manual step 2

   Fit the top rail, back slat and both seat rails into the side frame.

   The brackets face the inside of the seat — see the detail in step 2.

   ▶ Watch this step (0:32)

4. 

   Step 4 · manual step 3

   Place the second side frame on top.

   The dowels go into its holes.

   ▶ Watch this step (0:38)

5. 

   Step 5 · manual step 3

   Fasten it with 3 bolts (104322) and the Allen key.

   ▶ Watch this step (0:45)

6. 

   Step 6 · manual step 4

   Turn the chair over.

   ▶ Watch this step (0:53)

7. 

   Step 7 · manual step 4

   Fasten the other side with 3 more bolts (104322).

   Use the Allen key.

   ▶ Watch this step (0:58)

8. 

   Step 8 · manual step 5

   Set the chair upside down on a table.

   The backrest hangs over the edge of the table.

   ▶ Watch this step (1:06)

9. 

   Step 9 · manual step 5

   Fit the cross stretcher with 2 bolts (104322).

   It goes between the two low side stretchers. Use the Allen key.

   ▶ Watch this step (1:14)

10. 

    Step 10 · manual step 6

    Lift the frame and lay the seat face down under it.

    ▶ Watch this step (1:23)

11. 

    Step 11 · manual step 6

    Line the seat up evenly.

    It should stick out the same amount on both sides — see the detail in step 6.

    ▶ Watch this step (1:29)

12. 

    Step 12 · manual step 7

    Fix the seat with 4 screws (122925).

    Screw through the brackets with the Phillips screwdriver.

    ▶ Watch this step (1:35)

13. 

    Step 13

    Turn the chair upright.

    Your HAUGA chair is ready.

    ▶ Watch this step (1:44)