How to assemble IKEA GLENN Bar Stool

Step-by-step assembly

1. 

   Step 1

   Tap the 4 glides (120262) into the runners with a hammer.

   Stand both leg frames upside down — 2 glides in each runner.

   ▶ Watch this step (0:16)

2. 

   Step 2

   Turn both frames upright and put them together.

   The two tops meet side by side in the middle.

   ▶ Watch this step (0:24)

3. 

   Step 3 · manual step 2

   Bolt the frames together: 2 bolts (120199) and nuts (100716).

   Don’t tighten them fully yet — that is done in step 6.

   ▶ Watch this step (0:30)

4. 

   Step 4 · manual step 3

   Fit the footrest between the front legs — 2 bolts (120200).

   One bolt through each leg. Don’t tighten fully yet (step 7).

   ▶ Watch this step (0:39)

5. 

   Step 5 · manual step 4

   Press the 4 rubber cups (120833) into the holes on top of the frame.

   ▶ Watch this step (0:48)

6. 

   Step 6 · manual step 5

   Lay the seat upside down on a table.

   Use a soft cloth under it; the back hangs over the edge.

   ▶ Watch this step (0:55)

7. 

   Step 7 · manual step 5

   Turn the frame upside down onto the seat.

   Line up the 4 cups with the 4 holes in the seat.

   ▶ Watch this step (1:00)

8. 

   Step 8 · manual step 5

   Fix the seat with 4 bolts (100150) and the Allen key.

   Turn them by hand — don’t use a power drill.

   ▶ Watch this step (1:07)

9. 

   Step 9 · manual step 6

   Now tighten the 2 bolts (120199) in the middle.

   Hold the nut with the wrench and turn the bolt with the Allen key.

   ▶ Watch this step (1:16)

10. 

    Step 10 · manual step 7

    Tighten the 2 footrest bolts (120200) with the Allen key.

    ▶ Watch this step (1:24)

11. 

    Step 11 · manual step 8

    Turn the stool over and stand it on the floor.

    ▶ Watch this step (1:31)

12. 

    Step 12 · manual step 8

    If it rocks: put a weight on the seat and tighten the 2 middle bolts again.

    Wrench on the nut, Allen key on the bolt — as in step 6.

    ▶ Watch this step (1:37)