IKEA · Chairs & Stools
How to assemble IKEA FJÄLLBERGET Conference Chair with Casters
Step-by-step IKEA FJÄLLBERGET Conference Chair with Casters assembly: 9 illustrated steps, an animated video, the hardware list and the tools you need — following the official instructions (AA-2061865-6).
- 9 illustrated steps
- 4 steps in the manual
- 1:46 video
- 68×68×84 cm
What you need
Tools
- Allen key (included)
You’ll need: only the Allen key (108490), included.
Hardware in the box
| Part no. (as printed in the manual) | Qty |
|---|---|
| 117317 | 4× |
Step-by-step assembly
Step 1
Lay the base upside down and press in the 5 casters.
Push each caster straight in — not at an angle.
Step 2
Turn the base over onto its casters.
Step 3 · manual step 2
Put the gas cylinder into the hole in the centre of the base.
Step 4 · manual step 3
Lay the seat upside down on a soft surface.
It rests on the top of the backrest and the armrests.
Step 5 · manual step 3
Place the mechanism on the seat, lever to the side.
Line up the 4 holes in the plate with the holes in the seat.
Step 6 · manual step 3
Screw in the 4 bolts (117317).
Step 7 · manual step 3
Tighten each bolt clockwise with the Allen key (108490).
Step 8 · manual step 4
Turn the seat over and hold it above the base.
Step 9 · manual step 4
Press the seat down onto the gas cylinder.
The pin on the cylinder goes into the hole under the mechanism.
Tips & safety
- Adjust the seat height Lift the lever under the seat to raise or lower it (info box, manual step 4).
- Warning: gas cylinder Only trained personnel may replace or repair the seat height adjustment parts (manual p. 7–8).
- Safety casters They brake automatically when no one is sitting in the chair, so it stays where you left it (manual p. 9–10).
Official instructions
This guide follows IKEA’s official assembly instructions (AA-2061865-6). Keep the printed manual to hand — if anything differs, the manual is right.
