IKEA · Tables & Desks
How to assemble IKEA MITTZON Laptop Table with Casters
Step-by-step IKEA MITTZON Laptop Table with Casters assembly: 11 illustrated steps, an animated video, the hardware list and the tools you need — following the official instructions (AA-2394269-2).
- 11 illustrated steps
- 9 steps in the manual
- 1:54 video
- 66×50×96 cm cm
What you need
Tools
- Phillips screwdriver
- Allen key (included)
Hardware in the box
| Part no. (as printed in the manual) | Qty |
|---|---|
| 191061 | 4× |
| 101075 | 4× |
| 101072 | 1× |
| 10096541 | 2× |
Step-by-step assembly
Step 1
Swing the column up out of the packaging.
Leave the tabletop face-down in the tray. Check the tilt lever is pressed down — see the detail.
Step 2
Screw the end fitting onto the column with 4 screws (101075).
Phillips screwdriver.
Step 3
Place the base onto the end of the column.
Step 4
Fasten the base with 4 bolts (191061).
Use the Allen key (108490).
Step 5
Screw the 2 glides (10096541) into the leg ends.
Turn them in by hand.
Step 6
Lift the table out and turn it upright.
Step 7 · manual step 6
Push the cup holder into the end of the tube under the top.
On the left-hand end.
Step 8 · manual step 7
Lock the cup holder with the screw (101072).
Screw it in from underneath with the Phillips screwdriver.
Step 9 · manual step 8
Click the tray insert into the slot in the top.
One half from above, one from below — they snap together.
Step 10 · manual step 9
Slide the clip onto the edge of the top until it clicks.
Step 11
Step on the pedal to raise or lower the top.
Lift the top to the height you want, then release the pedal.
Tips & safety
- Tilting the top Lift the lever under the top to unlock the tilt, push it down to lock it again — see page 11 of the manual.
- Worn casters? They can be pulled off and replaced — see page 12 of the manual.
Official instructions
This guide follows IKEA’s official assembly instructions (AA-2394269-2). Keep the printed manual to hand — if anything differs, the manual is right.
