How to assemble IKEA DANDERYD Drop-Leaf Table

Step-by-step assembly

1. 

   Step 1

   Lay the tabletop face down on a rug.

   Press the 2 plastic slides (130652) into the holes in the leaves.

   ▶ Watch this step (0:16)

2. 

   Step 2

   Screw the 4 bumpers (114418) onto the corners of the leaves.

   1 screw (109049) each — Phillips screwdriver.

   ▶ Watch this step (0:24)

3. 

   Step 3

   Screw the 4 hinges across the joints.

   8 screws (100372) per hinge — 32 in all.

   ▶ Watch this step (0:32)

4. 

   Step 4

   Lay the 2 support bars side by side across the middle.

   Grey stop caps toward the centre; each bar end rests on a slide.

   ▶ Watch this step (0:42)

5. 

   Step 5

   Screw the bar bracket over both bars in the middle.

   3 screws (100372).

   ▶ Watch this step (0:49)

6. 

   Step 6

   Clip a U-clip (10087017) into the notch of each short rail.

   ▶ Watch this step (0:57)

7. 

   Step 7

   Turn the short rails over and set them across the bars.

   Each bar runs through the U-clip.

   ▶ Watch this step (1:04)

8. 

   Step 8

   Bolt the short rails to the top.

   2 bolts (105237) each — Allen key (100001).

   ▶ Watch this step (1:13)

9. 

   Step 9

   Push a corner plate (10035912) into each end of the short rails.

   ▶ Watch this step (1:21)

10. 

    Step 10

    Slide the 2 long rails into place on the corner plates.

    ▶ Watch this step (1:29)

11. 

    Step 11

    Bolt the long rails to the top.

    2 bolts (105237) each — Allen key.

    ▶ Watch this step (1:36)

12. 

    Step 12

    Stand a leg in each corner, square block against the rails.

    ▶ Watch this step (1:45)

13. 

    Step 13 · manual step 12

    Fit a washer (100833), spring washer (100843) and bolt (10047209).

    Through each corner plate into the leg; tighten with the spanner (128632).

    ▶ Watch this step (1:54)

14. 

    Step 14 · manual step 13

    Tighten all 4 bolts firmly.

    The washers must sit flat against the corner plate.

    ▶ Watch this step (2:05)

15. 

    Step 15 · manual step 13

    Turn the table over onto its legs.

    ▶ Watch this step (2:12)

16. 

    Step 16

    To lower a leaf: push its bar in, then fold the leaf down.

    To raise it: lift the leaf and pull the bar out under it — manual, info pages.

    ▶ Watch this step (2:20)